Dentrix Tip : Adding Surface/Quadrant Information to Multi-Codes

by Larry Emmott on October 22, 2019

in Paperless,Software

Adding Surface/Quadrant Information to Multi-CodesDuring the course of a single day, you routinely use procedure codes that require additional tooth information (such as surfaces, quadrants, etc). Do you get tired of entering this same information every time you post a procedure? Dentrix allows you to create multi-codes with this information already stored, which will save you time when posting work.You can preset the surfaces for procedure codes by setting them up as a multi-code.

Source: Dentrix Tip Tuesdays: Adding Surface/Quadrant Information to Multi-Codes

by: at .

Share

Comments on this entry are closed.

Previous post:

Next post: